Know the Use of Under- Pressure Cylinder not ‘Home Cylinder’

Source: Ningbo Yinzhou Danfeng Machinery Factory  Author :   Time: 2013-11-22

 

　　This process leads the cylinder bottom, the cylinder head to close the head and the bottom of the barrel respectively. The cylinder head lies at the side from where the piston rod exits the cylinder.

　　The cylinder bottom and the piston rod are attached with mounting brackets or clevises (U shaped device to hold the rod). This U-shaped device comes up with a hole at the end of each point through which a pin and even bolt can be hard-pressed to secure another part in place. The piston in the hydraulic cylinder is made up of sliding rings and seals. Inside the piston rod there are two chambers; the bottom chamber and the chamber lying within the cylinder.

　　The piston rod flinch moving outwards single acting cylinder, as the hydraulic fluid is propelled and pushed into the lowermost side of the hydraulic cylinder. In the opposite process, the hydraulic fluid is hard-pressed back into the basin by the piston. The force present in the cylinder is the proportion of unit force per unit piston area.

Company resources：rivet machine， riveting machine